Longines Quartz Watch Replacement Battery Does Not Go Troubleshooting

Quartz watches are relatively inexpensive, and the price is relatively low, and the time is accurate, so they are also loved by many watch friends. Longines quartz watches are undoubtedly an important choice for everyone to buy Swiss quartz watches.

As we all know, quartz watches need to be replaced after a certain number of years of use. Generally, we find that if the watch is not allowed to go, we need to consider whether we need to return a battery. Of course, more watch friends will wait until the watch is completely stopped.

It is relatively simple to replace the battery with a watch. Many watch friends will consider changing it by themselves, but often the watch will not go after the battery is replaced. Many watch friends will be a little scared. They worry that they are not operating properly and are damaged. The movement of the watch, in fact, is not necessary, we can slowly find out the problem and solve it.

  1. Do not panic when the quartz watch does not go. It may just be that the battery is not pressed with a screwdriver, and it may be loose. It may also be that the crown of the Longines watch is not pressed. These are all possible problems. Some watch friends have already changed the battery, but they have forgotten these details. Without checking, the watch will be reopened, which will greatly damage the body of the watch.

2, then the question to be considered is whether the battery has no electricity. When we eliminate the error, we must check the problem of the new battery. It may be a fake or expired battery and a newly replaced battery. It is also an old battery or a bad battery with insufficient power.

At this time, we need to remove the battery voltmeter to measure the voltage. If there is no voltage or the battery voltage is insufficient, then it is necessary to replace the new battery.

  1. If the battery voltage is normal, then it is necessary to consider the circuit problem. First, observe whether there is a foreign matter or rust and rust on the positive and negative contact springs of the contact battery. If so, the battery contact reed and the battery should be fully cleaned. And then reinstall it.
  2. If the above processing still fails to solve the problem, then the multimeter must be used to measure the circuit of the Longines watch. If the multimeter reads abnormally, it can only be sent to the repair shop to replace the coil or repair the movement. Non-professionals can handle it.